Current issue: 54(1)

Under compilation: 54(2)

Impact factor 1.683
5-year impact factor 1.950
Silva Fennica 1926-1997
1990-1997
1980-1989
1970-1979
1960-1969
Acta Forestalia Fennica
1953-1968
1933-1952
1913-1932

Articles by Daniel Eriksson

Category: Research note

article id 325, category Research note
Daniel Eriksson, Henrik Lindberg, Urban Bergsten. (2006). Influence of silvicultural regime on wood structure characteristics and mechanical properties of clear wood in Pinus sylvestris. Silva Fennica vol. 40 no. 4 article id 325. https://doi.org/10.14214/sf.325
The objective of the study presented here was to evaluate the influence of two contrasting silvicultural regimes on the structural characteristics and mechanical properties of different wood tissue types at different heights in Scots pine (Pinus sylvestris L.) trees, and reasons for these differences. Wood samples were taken from two stands (a dense 85-year-old stand established by direct seeding and a 56-year-old widely spaced stand established by planting, designated SDR and PWR, respectively in the boreal zone of Sweden). The wood properties associated with the examined silvicultural regimes differed, in terms of both structural characteristics (with up to fivefold differences between SDR and PWR) and mechanical properties (with up to almost threefold differences between SDR and PWR). Differences between the regimes were highest for stiffness, followed by strength and hardness properties and lowest for relative stiffness after 1000 h of loading (creep) (with higher parameter values for SDR than for PWR in each case). The rankings could be explained by differences among the mechanical properties in their sensitivity to maturation of wood characteristics. In conclusion, silvicultural regimes have great potential to regulate wood structural characteristics and mechanical properties, apparently due to the influences of the green crown and growth rate on the vascular cambium, the strength of which vary throughout the rotation period. A silvicultural regime could therefore be seen as a tool that can be used to select material qualities and to make wood a more homogenous material for engineers.
  • Eriksson, Swedish University of Agricultural Sciences, Vindeln Experimental Forest, Svartberget Fieldstation, SE-922 91 Vindeln, Sweden ORCID ID:E-mail: daniel.eriksson@esf.slu.se (email)
  • Lindberg, Luleå University of Technology, Division of Polymer Engineering, SE-971 87 Luleå, Sweden ORCID ID:E-mail:
  • Bergsten, Swedish University of Agricultural Sciences, Department of Silviculture, SE-901 83 Umeå, Sweden ORCID ID:E-mail:

Register
Click this link to register for Silva Fennica submission and tracking system.
Log in
If you are a registered user, log in to save your selected articles for later access.
Contents alert
Sign up to receive alerts of new content
Your selected articles

Committee on Publication Ethics A Trusted Community-Governed Archive