Current issue: 53(2)

Under compilation: 53(3)

Impact factor 1.683
5-year impact factor 1.950
Silva Fennica 1926-1997
1990-1997
1980-1989
1970-1979
1960-1969
Acta Forestalia Fennica
1953-1968
1933-1952
1913-1932

Articles by Philip M. O. Owende

Category: Research article

article id 437, category Research article
Raffaele Spinelli, Philip M. O. Owende, Shane M. Ward, Maximiano Tornero. (2004). Comparison of short-wood forwarding systems used in Iberia. Silva Fennica vol. 38 no. 1 article id 437. https://doi.org/10.14214/sf.437
Time studies were conducted to quantify the productivity and the operational cost of mechanized wood extraction in the Iberian Eucalyptus plantations. The key objectives were: to determine the significant variables that influence machine productivity and extraction costs in shortwood transport within the forest and to find the basis for optimization of shortwood transport with respect to Eucalyptus forest stands. Three machines were selected for study, each representative of the different log forwarding regimes that are used in Iberia and that could be extended to most of Southern Europe. These were: 1) a modified articulated dumper, 2) a purpose-built forwarder and 3) a farm tractor paired to a twin-axle forestry trailer. It was observed that the productivity and the cost of shortwood extraction may vary from 6 to 15 fresh tonnes/SMH and 3.5 to 6.5 Euro/fresh tonne, respectively. It was estimated that the optimal extraction route network covered approximately 10% of the forest surface. It was also observed that the modified dumper is the most-productive unit, and given its higher speed (> 5 km/h) and larger payload (16 tonnes), it is the economic choice for extraction distances in excess of 1000 m. However, it also generates the most severe rutting, hence it should be used with caution. For extraction distances below 1000 m, the light purpose-built forwarder compares favourably with the modified dumper, while generating less than half the site disturbance. The tractor-trailer combination is economically inferior to the modified dumper and the light forwarder, and should be regarded as a complement to the main extraction fleet and where short-haul operations are required. Under the assumptions of the study, light forwarders (8-tonne payload) may become competitive with heavier ones when road density is at least 6 m/ha, so that extraction distance does not exceed 1 km. This study provides a model for estimating the productivity and the cost of timber forwarding under varying conditions.
  • Spinelli, CNR - Timber and Tree Institute, Via Madonna del Piano - Pal. F, 50019 Sesto Fiorentino, Italy; University College Dublin, Ireland ORCID ID:E-mail: spinelli@ivalsa.cnr.it (email)
  • Owende, Dept. of Agricultural and Food Engineering, University College Dublin, Earlsfort Terrace, Dublin 2, Ireland ORCID ID:E-mail:
  • Ward, Dept. of Agricultural and Food Engineering, University College Dublin, Earlsfort Terrace, Dublin 2, Ireland ORCID ID:E-mail:
  • Tornero, Servicios Forestales SA, Ctra. SE-184 Km 0.63, E-41970 Santiponce, Sevilla, Spain ORCID ID:E-mail:

Register
Click this link to register for Silva Fennica submission and tracking system.
Log in
If you are a registered user, log in to save your selected articles for later access.
Contents alert
Sign up to receive alerts of new content
Your selected articles

Committee on Publication Ethics A Trusted Community-Governed Archive