Current issue: 54(1)
Under compilation: 54(2)
The paper presents a simple model of long-term forest management planning in tree plantations. The model is particularly suitable for developing countries where the research resources are limited. The management plan is prepared in two steps. First, one or several treatment schedules are simulated for each calculation unit (age class, compartment, etc.) over the selected planning period. Second, an optimal combination treatment schedules according to the selected objectives and constraints is searched by mathematical programming. The simulation of growth is based on the prediction of the diameter distribution at the desired time point. All stand characteristics are derived from this distribution. The models needed in the yield simulation can be estimated from temporary sample plots. A case study management plan for 13,000 ha of Pinus kesiya (Royle ex Gordon) plantations in Zambia is presented to demonstrate the system.
The PDF includes an abstract in Finnish.
The possibilities of using a pot method to determine the need for fertilizer application were studied. Seedlings of Scots pine (Pinus sylvestris L.) and Norway spruce (Picea abies (L.) H. Karst.) were grown in peat samples that had cylindrical shape with a diameter of 25 cm and height of 35 cm. The samples represented three different peatland types, and were fertilized with two levels of phosphorus, potash and nitrogen. Two transplants were planted per pot. The development of the seedlings was followed for three years.
Phosphorus seemed to be of greatest importance for the growth of the seedlings, but nitrogen was also required in the poorest peatland type. Potash did not give statistically significant results. NPK application gave the best response. The usability of the method was studied by following the development of the roots. It seemed that the diameter of the pots was too small and restricted the growth of the root systems.
The PDF includes a summary in English.
The study presents a growth and yield prediction model for a Pinus kesiya (Royle ex Gordon) stand by diameter classes. The material consists of temporary sample plots taken from a plantation inventory, of permanent sample plots established in commercial compartments and of an espacement trial. The mean basal area of the stand, variance and skewness of the diameter distribution are predicted. From these variables the parameters of the Weibull function are derived. Site class is assumed to be known or is calculated from measured information. Mortality is also predicted by estimating the number and mean size of dead trees. Thinnings are defined by the number of trees removed and by their relative size. If measured tree level data at the initial situation is available it can be utilized in the predictions, however, simulations can also be performed with stand level information. The minimum information needed for the prediction is planting density, site class as well as the times and removals of thinnings.
The calculations show that by decreasing the planting density of P. Kesiya from the present 1,330 stems/ha or by conducting early precommercial thinning both the relative and absolute amount of large sawlogs in the total production increase. An increase in the present planting density only slightly increases total yield. It is obvious that the presently recommended rotation of 25 years is too short for producing large sawlogs, especially on poor sites. This rotation period is suitable for small sawlog production while for pulpwood regimes shorter rotation periods can be used. If thinnings are done before the maximum current annual growth is reached stands will react well, but later on the ability to respond to thinnings decreases rapidly. Thinnings from below accelerates the production of large sawlogs more than thinning from above or systematic thinning. If all sawlog sizes are considered no great differences between thinning type exist. The study recommends different thinning regimes according to site class. Separate programs are recommended for the production of sawlogs and pulpwood.
The used thinning reaction model needs refinement and further studies with annual measured thinning trial material.
The PDF includes a summary in Finnish.