Current issue: 53(2)
Under compilation: 53(3)
The aim of the study was to find out what are the causes of damage in different parts of the trees and the frequency of different kinds of injuries. Sample plots were studied in over 80-year old forests in mineral soil sites and peatlands. All the trees over 1.5 m high were felled in the sample plots and the stem injuries were studied. The structure of the stand and the crown classes were recorded. The proportion of undamaged trees was largest in in dominant and codominant trees and increased towards the better forest site types. The typical injuries are listed for Scots pine (Pinus sylvestris L.), Norway spruce (Picea abies (L). H. Karst.) and Betula sp. stands. The injuries were divided in inner and outer form defects and injuries, and defined in more detail by the part of the stem and tree species. Defects caused by decay were analyzed separately.
Healing over of injuries was faster in the better sites. Form defects and other injuries were more common in birch stands than in Scots pine and Norway spruce stands. Decay was most common in birch stands. The pine stands were the healthiest, followed by spruce stands. Fire wound were most usual in pine, butt rot for spruce, and crooks and general decay for birch.
The PDF includes a summary in German.
The aim of the present study was to find the factors influencing the distribution of Norway spruce (Picea abies (L.) H. Karst.) logs on various grades with special stress on the effects of the grade on the value of logs. The material was obtained from ten sawmills located in Southern Finland by grading a total of 13,559 logs.
The results showed that knottiness in its different forms of appearance is the most important factor influencing the quality of spruce logs. Its significance is clearly greater in spruce than in Scots pine saw logs. Among the other defects, the most common are crooks. Even scars and decay occur to a considerable degree, but other defects seldom affect the grade. The quality of butt logs is markedly better than that of top logs. Both in butt and top logs the smallest logs in diameter are of poorer quality. However, in the largest diameter classes the quality begins again to decrease.
The difference in the quality of logs of the same grade at various sawmills is very small. The results of grading at varying times at the same sawmill show greater differences than can be observed between different sawmills. However, the logs of sawmills that procure the timber from coastal areas and islands are inferior to those which procure the timber from the mainland.
The PDF includes a summary in English.