Current issue: 54(2)

Under compilation: 54(3)

Impact factor 1.683
5-year impact factor 1.950
Silva Fennica 1926-1997
1990-1997
1980-1989
1970-1979
1960-1969
Acta Forestalia Fennica
1953-1968
1933-1952
1913-1932

Articles containing the keyword 'press drying'.

Category: Research article

article id 198, category Research article
Henrik Heräjärvi. (2009). Effect of drying technology on aspen wood properties. Silva Fennica vol. 43 no. 3 article id 198. https://doi.org/10.14214/sf.198
This article reports the impacts of three different drying treatments on selected physical and mechanical properties of European (Populus tremula L.) and hybrid (P. tremula x tremuloides) aspen wood. The material originates from 5 European aspen stands and 7 hybrid aspen stands in southern and central Finland. After processing the logs at a saw mill, sawn timber samples were dried using 1) conventional warm air drying, 2) press drying, or 3) heat treatment into Thermo-S grade by the Finnish Thermowood® method. Finally, small clearwood specimens were manufactured from different within-stem positions for the measurements of physical and mechanical properties. Both press dried and heat treated specimens absorbed water at significantly slower pace than the conventionally dried specimens. In normal climate, the conventionally dried, press dried and heat treated specimens conditioned at equilibrium moisture contents of 12.2, 8.7, and 8.9 per cent, respectively. It appears that the butt logs between 2–6 metres contain the lightest and, thus, weakest wood in aspen stems. Radial compression strength was at its highest in heat treated specimens, whereas conventionally and press dried specimens did not differ from each other. Press dried specimens had the highest longitudinal compression strength, also heat treated specimens showed higher values than the conventionally dried ones. Radial Brinell hardness of press dried specimens was higher than that of conventionally dried or heat treated specimens. Both modulus of elasticity and modulus of rupture were at their highest in press dried specimens. Irrespective of the drying treatment, the tangential shear strength of European aspen specimens was approximately 5% higher than that of hybrid aspen. Heat treated specimens indicated significantly lower tangential shear strength values than the conventionally dried ones. In case of both aspen species, the longitudinal tensile strengths of heat treated specimens were significantly lower than those of conventionally and press dried specimens. Heat treated specimens had the highest variability among the results. The inherent flaws in aspen wood material, e.g., wetwood and density
  • Heräjärvi, Metla, Joensuu Research Unit, Box 68, FI-80101 Joensuu, Finland ORCID ID:E-mail: henrik.herajarvi@metla.fi (email)

Register
Click this link to register for Silva Fennica submission and tracking system.
Log in
If you are a registered user, log in to save your selected articles for later access.
Contents alert
Sign up to receive alerts of new content
Your selected articles

Committee on Publication Ethics A Trusted Community-Governed Archive