Current issue: 53(4)
Under compilation: 54(1)
The purpose of this study was to measure workers’ exposure to MCPA and glyphosate when sprayers connected to the brush saws was used. A non-pressurized sprayer with a pump and a pressurized sprayer where dosage was regulated with manual control were studied. Exposure was measured from the breathing zone and urine samples.
MCPA collected from the breathing zone gathered into alcohol was 0.05 mg/m3 for the pressurized sprayer, 0.02 mg/m3 for the non-pressurized sprayer, and 0.04 mg/m3 (average) for both types of sprayers together.
MCPA in the breathing zone, collected from splashes and fog into a glass fibre filter, was 0.18 mg/m3 for the pressurized sprayer, 0.09 mg/m3 for the non-pressurized sprayer, and 0.12 mg/m3 for both sprayers used together. Glyphosate in the breathing zone, collected into sodium hydroxide was below 0.05 mg/m3.
In five urine samples taken after the work day there was on the average 0.4 mg/l MCPA, while in 21 samples the MCPA contents were under the definition limit (0.2 mg/l).
The PDF includes a summary in Finnish.
The aim of the study was to compare the newly introduced brush cutter to ordinary hand tools in clearing of cutting areas and thinning young birch (Betula sp.) and Scots pine (Pinus Sylvestris L.) stands. Working with a prototype of the brush cutter, Brushmaster, reduced the total working time by 15-20% compared to bush knife and axe, in spite of the cutter’s weight. At rainy weather the advantage of Brushmaster dissapeared because of clogging of the cutter’s air filter. The prototype proved to be more effective when clearing a cutting area, and hand tools seemed to be faster if damage to the remaining trees have to be avoided.
In addition, eight either lighter or more effective motor saws or brush cutters were compared mutually, and the effect of motor effect, weight, handiness, arrangement of suspenders and handles is discussed. With these improved types of the cutter it was possible to shorten the total working time in thinning of stands (mostly clearing of young stands) to 30-40% of the total working time compared to hand tools. The most modern saws appeared to be best adapted in clearing cutting areas.
The article includes an abstract in English.