Jacob Edlund , Mats Warensjö

Repeatability in automatic sorting of curved Norway spruce saw logs

Edlund J., Warensjö M. (2005). Repeatability in automatic sorting of curved Norway spruce saw logs. Silva Fennica vol. 39 no. 2 article id 388. https://doi.org/10.14214/sf.388

Abstract

Sawn wood from curved logs is prone to have cross grain and contain compression wood, both of which affect the dimensional stability. Different types of curvature can, however, have different effects on both the sawing process and board quality, which is why a standard measure of bow height alone is not enough to sort logs or set the log quality. The aim of this study was to evaluate the repeatability when sorting curved saw logs using a 3D log scanner. In the study, 56 logs were categorized into five different curvature types and four different degrees of curvature severity. The logs were run through a Rema 3D log scanner four times, and the external geometry was recorded. From the geometry data, variables describing log shapes were calculated and used to develop models using linear discriminant analysis, which was used to classify the logs according to curvature type. The accuracy and repeatability were evaluated for the classifications with Cohen’s simple Kappa coefficient. The results of this study showed that it is possible to sort logs by curve type using a 3D log scanner, although sorting by curve type was largely dependent on curve severity. The repeatability test determined that the chance of a curved log being graded identically two consecutive times was 0.40, measured as kappa.

Keywords
Picea abies; compression wood; stem form; bow; scanner; sorting

Received 31 August 2004 Accepted 30 March 2005 Published 31 December 2005

Views 3359

Available at https://doi.org/10.14214/sf.388 | Download PDF