Quality and yield of pulpwood in drained peatland forests: pulpwood properties of Scots pine in stands of first commercial thinnings
Varhimo A., Kojola S., Penttilä T., Laiho R. (2003). Quality and yield of pulpwood in drained peatland forests: pulpwood properties of Scots pine in stands of first commercial thinnings. Silva Fennica vol. 37 no. 3 article id 494. https://doi.org/10.14214/sf.494
Abstract
The inherent structural dynamics of drained peatland forests may result in a great variation in various wood and fiber properties. We examined variation in fiber and pulp properties i) among stands, ii) among trees within stands, and iii) within trees in young stands dominated by Scots pine (Pinus sylvestris L.). The stands, selected to cover a maximal range of the potential variation, were all at a stage of development where the first commercial thinnings would be feasible. Differences in the processability of the thinning removals were small. In similar kraft cooking conditions, a 5-unit variation in the kappa number of unbleached pulp was observed among the stands. Stand origin had no effect on pulp bleaching. The wood formed prior to drainage had a higher density, shorter fibers, was slightly slower delignified by cooking, and its yield was slightly lower than that of post-drainage wood. These properties, except for high density, are typical for juvenile wood in general, and at stand level they did not correlate with the proportion of pre-drainage wood. When the variation in fiber and pulp properties was broken down into its components, most of it was derived from tree-level in all the cases. On average, the fiber and pulp properties did not differ from those observed for first-thinning pulpwood from upland sites. Consequently, peatland-grown pulpwood may be mixed with other pulpwood in industrial processes. It would probably be best suited as the raw material for pulps with high bonding requirements, e.g. in the top ply of multi-ply board grades or in some specialty grades.
Keywords
Pinus sylvestris;
peatland;
thinning;
silviculture;
pulpwood;
fiber;
pulping
Received 29 October 2002 Accepted 21 March 2003 Published 31 December 2003
Views 4586
Available at https://doi.org/10.14214/sf.494 | Download PDF