Select issue
Silva Fennica 1926-1997
1990-1997
1980-1989
1970-1979
1960-1969
1950-1959
1940-1949
1926-1939
Acta Forestalia Fennica
1992-1999
1984-1991
1974-1983
1968-1973
1953-1968
1933-1952
1913-1932
Articles containing the keyword 'polymer'
Category : Research article
article id 607,
category
Research article
(2001).
Plastic coating of plywood using extrusion technique.
Silva Fennica
vol.
35
no.
1
article id 607.
https://doi.org/10.14214/sf.607
Keywords:
plywood;
thermoplastics;
polymer;
polyethylene;
polypropylene;
extrusion coating;
adhesion
Abstract |
View details
|
Full text in PDF |
Author Info
The target was to study and develop industrially suitable methods to apply thermoplastic coatings on plywood. Typically, wear and climatic resistance for wooden sheets, such as chip board and plywood, is achieved by thermosetting resin coating (e.g. phenol-formaldehyde). However, economical and environmental issues are driving towards thermoplastic coatings (e.g. polyethylene) in such products. Several technologies, such as film gluing and laminating, have been introduced, but the costs and processing are limiting factors. This study concentrates on direct coating of plywood with extruded molten plastic film, in other words extrusion coating of plywood. This technique provides fast coating process and cheap raw materials. In the study it was found that extrusion coating of plywood is difficult. The high heat energy of the molten plastic causes moisture evaporation of the top veneer, and the only possible escape direction of the evaporated moisture is through the plastic, which causes bubbling in the plastic coating. Another disadvantage of the plywood is its rigidity, which limits the development of the process. In this work, a new technique was applied for coating the flexible veneers with typical extrusion coating equipment, where the escape of the evaporated moisture was possible through the top veneer to the atmosphere. Another main issue was to reach sufficient adhesion between plastic and plywood. Target was achieved using either monolayer polyethylene (PE-LD) or 2-layer polypropylene/adhesion polymer plastic coatings.
-
Kuusipalo,
Tampere University of Technology, Institute of Paper Converting, Korkeakoulunkatu 4 C, P.O. Box 541, FIN-33720 Tampere, Finland
E-mail:
jurkka@cc.tut.fi
Click this link to register to Silva Fennica.
If you are a registered user, log in to save your selected articles for later access.
Your selected articles
Silva Fennica ·
Finnish Society of Forest Science
