Current issue: 58(5)
Silva Fennica vol. 9 | 1975
Category : Article
The article reviews the position of the Department of Forest Technology in Finnish Forest Research Institute, among Finnish establishments in research on forest work. In addition, it describes the current research programmes of the departments both in wood harvesting studies and studies on silvicultural work. The equitable aims of the former are to increase productivity, lower the cost level, ease the work and improve job satisfaction, as well as to improve the utilization of wood raw material. The latter aims at e.g. improvement of the biological results.
Future prospects are surveyed from the point of view of the goals imposed by the State on the research and, on other hand, the appropriations earmarked for forest work science. A regrettable conflict has arisen between them.
The PDF includes a summary in English.
-
Hakkila,
E-mail:
ph@mm.unknown
The utilization of stump and root wood is analysed in this paper on the basis of literature from middle of 19th century to the present date. According to the information available, the utilization of pine stumps in tar production was small compared to that of peeled Scots pine stemwood in the 19th century. During the 1st and 2nd World War the utilization of stumps for tar production reached its highest levels. Other industrial utilization of stumps has been small up to the present time but now stumps are beginning to be used in the pulp industry.
The greatest amounts of stumps have been utilized by the rural population. Stumps were used as fuel. In the thirties, the yearly amount used was over 200,000 m3 (solid measure), and even in the sixties over 100,00 m3. No industrial utilization method has yet reached these levels.
The PDF includes a summary in English.
-
Kärkkäinen,
E-mail:
mk@mm.unknown
The study sought to establish, whether a connection between forest ownership changes and regional differentiation process exists. Data were collected by interviewing fifty persons representing regional planning and forestry. In 1969–72 forest land area owned by the farmers decreased by some 600,000–700,000 hectares. The new owners were non-farmers (400,000–500,000 ha) and the State and forest industry companies (200,000 ha). These figures indicate a possibility for a reduction in the livelihood of rural developing regions in three ways: money incomes with their multiplier effects decrease, possibilities of the rationalization of farming decrease and the population confidence in the future diminishes.
The PDF includes a summary in English.
-
Reunala,
E-mail:
ar@mm.unknown
The material of this study consists of 1,080 Scots pine (Pinus sylvestris L.) saw logs measures in two saw mills in Northern Finland. The largest and the smallest top-diameter of each log was measured under bark. According to the results, the ovalness was rather small, 1 mm or 4.9% on average. On the other hand, only 14.3% of all logs showed a diameter difference smaller than 2%. The ovalness was larger than 10% in 5.8% of all logs.
The PDF includes a summary in English.
-
Kärkkäinen,
E-mail:
mk@mm.unknown
The ash content has been found to correlate with the fertility of peatlands. Relationship between height of 80-year-old stands and ash content of peat in topmost 30 cm layer was examined in Lithuanian conditions. On drained peatlands with ash content of peat from 3% to 8% pine stands increase in height. Ash content of peat being about 7% Scots pine (Pinus sylvestris L.) and Norway spruce (Picea abies (L.) H. Karst.) stands on drained sites are found to be of equal height. Ash content of peat more than 8–9% has no significant effect on growth of pine or spruce stands. Birch (Betula verrucosa (B. Pendula Roth.) and Betula pubescens Erhrh.), stands are less sensitive to ash content of peat compared with other species. Black alder (Alnus glutinosa L. Gaertn.) stands occurred in sites with ash content of peat more than 8–10%. The height of the stands become equal both in drained and undrained sites in the cases where ash content of peat is about 16–18%. Ash (Fraxinus exelsior L.) stands attain high productivity on drained sites with ash content of peat about 20%.
The PDF includes a summary in English.
-
Kapustinskaité,
E-mail:
tk@mm.unknown
In the first place the term short-rotation forestry is being used in the sense of intensive tree growing during a short rotation time using reproduction by coppice shoots from broad-leaved tree material which has been specially bred for this purpose, or of producing fast-growing varieties from planted stock during the course of somewhat longer rotation time (maximum 20 years). However, short-rotation forestry as such has already a long history.
In the Fertile Crescent in ancient Egypt grew no tree species suitable for short-rotation production, but reeds and bulrushes were used for the same purpose as willow-twigs, e.g. wickerwork or binding. At least in the Fertile Crescent reed harvesting using a rotation of one year was practiced already very long ago. The earliest information about coppice-shoot cultivation is found in Greek literature, but it was the Romans who developed short-rotation forestry based on the trees’ capacity of reproducing through coppice shoots into an extensive economic activity. Willows were by far the most important species used. Twigs intended for wickerwork were harvested once a year and thicker material, to be used for support and in basket framework, every fourth year. Chestnut and oak were used for the production of slightly thicker poles employing a longer rotation. Cypress poles were produced from seedlings using a rotation time of 12–13 years. Roman scholars give us plenty of information concerning the tending of plantations in short-rotation forestry.
The PDF includes a summary in English.
-
Makkonen,
E-mail:
om@mm.unknown
The aim of the study was to determine the extent to which the cross section of birch (Betula sp.) and aspen (Populus tremula L.) logs differ from a circle and to test some simple methods for measuring the cross-sectional area which can be used, for instance, for determining the volume of the logs. The material consisted of 420 debarked birch disks and 240 aspen disks which were representative of the logs arriving at two factories.
The convex deficit values for the material were very small, the cross-sectional area error being in general less than 1%. On the other hand, the other parameters deviated from the circular form to quite a large degree. It was also evident that the radii measured from the piths to the surface of the wood varied considerably more in the same disk, as regards length, than the diameters measured in different directions.
It was evident that the shape of the average cross-sectional area was not in general elliptical. It thus appears that any method for measuring the cross-sectional area which is based on elliptical formula is not suitable. The method which gave the best result was that in which the cross-sectional area was taken as the average of the area of the circle calculated from the smallest diameter and that calculated from the diameter passing at right angles to it. This method also appeared to be the best for disks which deviated to quite a large degree from the circular form. The suitability of this method is increased by the fact that the relative error is only slightly dependent on the size of the disk.
The PDF includes a summary in English.
-
Kärkkäinen,
E-mail:
mk@mm.unknown
During the next decade there will be a marked increase in the allowable cut in drained peatlands. At the same time, the mechanization in logging proceeds, and in short-distance haulage the use of forwarders will increase. This study, based on literature and some observations, deals with logging conditions in drained peatlands with special reference to the suitability of heavy logging machines for use in such terrain. In addition, soil frost and the bearing capacity of the frozen peat soil were studied.
Freezing of the soil in a drained peatland area depends prevailingly on the weather conditions during early winter. The factors influencing soil freezing of a drained peatland are completely different from those regulating the freezing of natural peat soils. The frost penetrates in general deeper in the drained than virgin peatland. The topmost peat layer does not, however, freeze uniformly. Generally speaking, the bearing capacity of a drained peat soil is lower than that of undrained peat due to lower water content.
It is concluded that heavy logging machines are probably not fitted for use in drained areas on peatland even if the average soil frost values recorded would suggest it. Moreover, because of their extremely superficial root systems, peatland forests are exposed to damages by heavy machines in thinning operations.
The PDF includes a summary in English.
-
Hannelius,
E-mail:
sh@mm.unknown
Peat industry is rapidly expanding in Finland. Consequently, during next decades peat will be removed from thousands of hectares. Because timber production probably is the most rational use of this area after the peat production has ended, some experiments of afforestation of such areas have already been conducted. This article reports results of two experiments which were started in Kihniö, Western Finland, in 1953 and 1964.
In the first experiment fertilization with wood ash proved very effective whereas seeding and planting without fertilization resulted in almost complete failure. In the second experiment, interplanting with grey alder (Alnus glutinosa L. Gaertn.) greatly promoted the growth of Scots pine (Pinus sylvestris L.). The effect of slight fertilization lasted a few years only. The reasons for the remarkable effect of alder need further research. Although alder is known as a nitrogen-fixing plant, its beneficial effect was most clearly seen in the K and P contents of pine needles. Inoculation with mycorrhizal fungi was beneficial but not necessary. Experiments hitherto show that afforestation of bogs after peat removal is possible although some additional measures like fertilization or interplanting with alder may be needed.
The PDF includes a summary in English.
-
Mikola,
E-mail:
pm@mm.unknown
Since the year 1966, fourteen specialists, most of them forestry graduates from Kasetsari University in Bangkok, have studied or will start studying in Finland. The visiting graduate students have completed their program successfully, and are interested, as well as the Thai authorities, in continuing the educational cooperation. However, the Finnish Government now seems to have changed the list of countries which are included in this kind of program. The Thai authorities will possibly grant a limited number of scholarships for studies carried out in Finland. The possible need to develop the study program further is discussed if the educational cooperation with Thailand will continue.
The PDF includes a summary in English.
-
Luukkanen,
E-mail:
ol@mm.unknown
The planning of timber production in a forestry unit is divisible into two phases. In the first phase, planning provides the decision-maker with a number of possible timber production policies; these policies define the production possibility boundary. After the decision-maker has chosen one of these policies, planning moves to the second phase, in which a detailed programme is prepared with a view to meeting the requirements of the timber production policy accepted. The paper indicates one possibility of solving these two tasks simultaneously. In the first phase, the solution of the primal linear programming problem is employed and in the second phase the respective dual or shadow price solution.
The PDF includes a summary in English.
-
Kilkki,
E-mail:
pk@mm.unknown
- Pökälä, E-mail: rp@mm.unknown
- Siitonen, E-mail: ms@mm.unknown
The aim of the study was to assess the use and importance of forestry publications issued by the Finnish Society of Forestry (now the Finnish Society of Forest Science) and the Finnish Forest Research Institute in disseminating research information. Another goal is to obtain information required for planning publication policy. The material was collected by means of two postal inquiries. For the first of these, a sample of 200 subscribers was taken from the mailing lists of the publication series in question. Similarly, for the second inquiry a sample of 100 professional foresters was drawn from the membership registers of the Union of Finnish Foresters and of the Union of Forest Technicians, respectively. The reply percentage of the subscribers was 72 and that of the professional foresters 64. The publication series most actively read proved to be Folia Forestalia, which was also estimated to be of the best quality. Differences between the various publication series in relation to properties studied were not very great.
The PDF includes a summary in English.
-
Heiramo,
E-mail:
th@mm.unknown
It is possible to show that many of the after-effects resulting from the disappearance of forest cover were well known already in ancient times. The invigorating effect of moving around freely in the forest and its artistic creative ability were also recognized as well as the healing effect of coniferous forest on people suffering from consumption. Hunting and the use of forests for cattle grazing is also an extremely old practice. The so-called by-products of the forest such as tree bark and leaves, as well as berries and fruits, have played an important role in the history of mankind from the very earliest beginnings.
The PDF includes a summary in English.
-
Makkonen,
E-mail:
om@mm.unknown
The paper deals with the optimization of roundwood transport in cases where many destinations for it exist and where several means of transport are available. It is also understood that the capacities of the factories to which wood is transported can be used at varying degree. A model was developed for a case such as Finland which sells most of its products abroad.
In the above case, the optimization of roundwood transport does not necessarily mean minimization of transport costs. What is aimed at is to obtain, by using different combinations (mill destinations and the media of transport) the maximum difference between the allowable cut (calculated) and real (actual) transport costs.
The PDF includes a summary in English.
-
Roitto,
E-mail:
yr@mm.unknown
The paper, which was written already at the turn of the year 1950–51, gives a quite detailed description of the early history of the Act on Forest Owners’ Associations, which was passed on 17 November 1950 and is still in force, of the long-lasting and multifarious preparations involved with it, and of its consideration in the parliament. In most parties there were both supporters and opponents; only the social democrats voted harmoniously for the act and the people’s democrats against it.
The PDF includes a summary in English.
-
Piha,
E-mail:
ap@mm.unknown
The task of the study was to describe the opinions of the forestry experts engaged in the State forestry organization and the organization for promotion of private forestry, and of the appointed representatives in the organization for the promotion of private forestry concerning the official forestry administration and its development. The study material was based on two samples, one of 240 forestry experts and the other of 290 appointed representatives. The data was compiled by mail inquiry.
Forestry experts were found to rate the success of the official forestry administration in its tasks lower than did the appointed representatives. Both the forestry experts and appointed representatives were of the opinion that the official forestry administration has been most successful in accomplishing timber production and least successful in the tasks concerning multiple use of forests. The results also indicate that 44% of the forestry experts were of the opinion that the most suitable organization model would be a uniform state organization for both the State, and private owned forests. About a third of the forestry experts considered that the best model would be two different state organizations, one for the State forests and the other for the private forests. 62% of the appointed representatives were of the opinion that the best solution would be to retain the official forestry administration such as it is now.
The PDF includes a summary in English.
-
Järveläinen,
E-mail:
vj@mm.unknown
The study deals with the relationship between biomass and coverage in ground vegetation of Vaccinium and Calluna forest types. The results show that the biomass of the field layer on both forest types can predict satisfactorily in both coverage values of some the most important species and groups of species. Their total height per plot was used as independent variables. The explaining power of the models constructed for Vaccinium type increased to approximately 57% and for the Calluna type to approximately 74% of the total variation in the amount of dry matter. When the biomass of the bottom layer was predicted using the same kind of variables, the explaining power for the Vaccinium type increased to approximately 35% of the total variation and for the Calluna type approximately 53% of the total variation in the amounts of dry matter. The models for field layer of both Vaccinium and Calluna types were quite well suited for describing the test material. In the case of the bottom layer, the constructed models were not suitable for describing the test material.
The PDF includes a summary in English.
-
Kellomäki,
E-mail:
sk@mm.unknown
