Silva Fennica vol. 23 no. 2 | 1989
Category : Article
In this article the methods of forest valuation, especially the sales value tables previously published in Finland are critically examined. In this connection attention is drawn to the rate of interest used in calculating the forest values.
The PDF includes an abstract in English.
-
Hämäläinen,
E-mail:
jh@mm.unknown
The condition of forest road pavements was studied in spring, one week after maintenance and in autumn. The effect of vibrating blade was slightly better than that of pulled drag. Large loose stones couldn’t be pressed into pavement with either of the implements. The use of the vibrating blade was three times as expensive as the use of the pulled drag, however, the blade is suitable for other purposes as well.
The PDF includes an abstract in Finnish.
-
Rummukainen,
E-mail:
ar@mm.unknown
The study uses the methodology of ecological field theory to model the effect of Scots pine (Pinus sylvestris L.) seed trees on the density of tree seedlings and other plants in the field layer. The seed trees had a clear effect on the expected value of the amount and distribution of the ground vegetation. The vicinity of seed trees had an adverse effect on the growth of grasses, herbs and seedlings, while mosses were most abundant near the trees. Models based on the ecological field approach were derived to describe the effect of seed trees on the ground vegetation.
The PDF includes an abstract in Finnish.
-
Kuuluvainen,
E-mail:
tk@mm.unknown
- Pukkala, E-mail: tp@mm.unknown
The material of the study consisted of 21 Scots pine (Pinus sylvestris L.) trees that had been pruned in the 1930’s and 1940’s. The butt log of the pruned stems was peeled into veneer from which the length and shape of the resin taps were determined. The length of the resin tap was affected in the first place by the knot diameter and the height of the knot along the stem. The length of the resin tap was about 1.5-fold that of the knot diameter. With an increase in the height above the ground of a knot, its length decreases. The resin taps were particularly long on poor sites and in the butt end of the stems, however, the variation in tap length was large both within and between the individual tree stands. The shape of the resin taps is presented in this study by diameter classes. The resin taps studied in the work were longer than those measured in other works. This may be due to the fact that the knots were uncovered by peeling instead of sawing.
The PDF includes an abstract in Finnish.
-
Pietilä,
E-mail:
jp@mm.unknown
The results of an intercalibration of sulphur analysis by 24 laboratories are evaluated. The analysis was made by one or more of six methods. The following three methods were found to be satisfactory as regards relative speed and reliability: Leco S analysis, X-ray fluorescence, and vacuum ICO emission spectroscopy.
The PDF includes an abstract in English.
-
Jarva,
E-mail:
mj@mm.unknown
- Tervahauta, E-mail: at@mm.unknown
The single tree growth models presented in this study were based on about 4,000 trees measured in 50 even-aged Scots pine (Pinus sylvestris L.) sample plots with varying density, spatial pattern of trees and stand age. Predictors that used information about tree locations decreased the relative standard error of estimate by 10 percentage points (15%), if past growth was not used as a predictor, and about 15 percentage points (30%) when past growth was one of the predictors. When ranked according to the degree of determination, the best growth models were obtained for the basal area increment, the next best for relative growth, and the poorest for diameter increment. The past growth decreased the relative standard error of estimate by 15–20 percentage points, but did not make the spatial predictors unnecessary. The degree of determination of the spatial basal area growth model was almost 80% if the past growth was unknown and almost 90% if the past growth was known. Variables that described the amount of removed competition did not improve the growth models.
The PDF includes an abstract in Finnish.
-
Pukkala,
E-mail:
tp@mm.unknown
The study presents two methods of predicting tree dimensions in a Scots pine (Pinus sylvestris L.) stand if only the location of trees is known. The first method predicts the tree diameter from the spatial location of neighbours. In the second method the diameter distribution of a subarea is estimated from the local stand density. This distribution is then sampled to obtain diameters. In both methods the tree height is predicted with a spatial model on the basis of diameters and locations of trees. The main purpose of the presented models is to generate realistic stands for simulation studies.
The PDF includes an abstract in Finnish.
-
Pukkala,
E-mail:
tp@mm.unknown
