Paavo Yli-Vakkuri, Aimo Autio, Juhani Vehkaoja. (1968). Päätehakkuun ja metsänviljelyn välinen aika. Silva Fennica vol. 2 no. 3 article id 4769. https://doi.org/10.14214/sf.a14554

English title: Time lag between final cutting and regeneration.

Original keywords: kylvö; metsänviljely; istutus; uudistaminen; uudistusaika; istutusrästit; viivästys

English keywords: planting; final felling; sowing; artificial regeneration; seeding; time lag

Abstract | View details | Full text in PDF | Author Info

The time interval between final felling and plantation means a waste of time and thus a production loss, and may lead to lush growth of ground cover and hardwood sprouts, which increases expenses in forest management. The objective of this study was to determine the length of time between final felling and artificial regeneration in private forests in the forest districts of Uusimaa-Häme in Southern Finland and Pohjois-Häme in Central Finland. The material consists of a sample of 150 plans of the 952 cutting and regeneration plans in the district of Uusimaa-Häme and a sample of 140 plans of the 1,102 plans in Pohjois-Häme.

The time lag between final cutting and seeding or planting was on average 1.4 years in Pohjois-Häme district and 0.7 years in Uusimaa-Häme. In the latter district, 56% of the logged area was regenerated in the spring immediately following the cutting, and 84% not later than in the second spring. In Pohjois-Häme, 29% of the harvested area was regenerated immediately in the first spring following cutting, and 79% not later than in the third spring following cutting.

In Pohjois-Häme, the interval was shortest in the smallest forest holdings, and longest in the largest holdings with the largest regeneration areas. The length seems to depend mainly on the size of the regeneration area. In Uusimaa-Häme district, the interval was shortest in the smallest holdings, rather short in the largest, and longest in the intermediate-size forest properties. Seeding with Scots pine (Pinus sylvestris L.) was used in almost all regeneration areas.

The forest owners had mainly carried out the regeneration work themselves. In the Pohjois-Häme area, the interval was shorter when the district forestry board regenerated the area. 35% of the regenerated areas had required supplementary planting in Pohjois-Häme, and 47% in the Uusimaa-Häme area. Supplementary planting was more common in areas regenerated later after the cutting. In Pohjois-Häme, according to the reports of the forest owners, 75% of the regenerated areas required tending during the first three years, in Uusimaa-Häme, 80%.

The PDF includes a summary in English.

Yli-Vakkuri, E-mail: py@mm.unknown
Autio, E-mail: aa@mm.unknown
Vehkaoja, E-mail: jv@mm.unknown

article id 4569, category Article

Martti Tertti. (1939). Näkökohtia kuusimetsän hoidosta. Silva Fennica no. 52 article id 4569. https://doi.org/10.14214/sf.a13976

English title: Forest management of Norway spruce forests.

Original keywords: hakkuut; kuusi; Picea abies; metsäopetus; metsänhoitajien jatkokurssit; päätehakkuu; jatkokoulutus; harvennushakkuu; sekametsä; koivu; Betula sp.

English keywords: Norway spruce; birch; thinnings; mixed forests; final felling; fellings; forest education; professional development courses; thinning from below

Abstract | View details | Full text in PDF | Author Info

Silva Fennica issue 52 includes presentations held in professional development courses, arranged for foresters working in public administration in 1938. The presentations focus on practical issues in forest management and administration, especially in regional level. The education was arranged by Forest Service.

This presentation describes different types of fellings in Norway spruce (Picea abies (L.) H. Karst.) forests in different forest site types. The use of thinning from below and above, clear cutting of Norway spruce stands, and thinning of mixed forests with birch (Betula sp.) are discussed.

Tertti, E-mail: mt@mm.unknown

Category : Research article

article id 1265, category Research article

Eva Ring, Lars Högbom, Hans-Örjan Nohrstedt, Staffan Jacobson. (2015). Soil and soil-water chemistry below different amounts of logging residues at two harvested forest sites in Sweden. Silva Fennica vol. 49 no. 4 article id 1265. https://doi.org/10.14214/sf.1265

Keywords: clearcutting; final felling; bio fuel; conifer; fuel-adapted felling; nutrient; soil solution

Highlights: Soil-water chemistry, ground vegetation cover and water flux were affected by the amounts of logging residues stored on the ground after harvest; A strong response on soil-water chemistry was recorded at only one of the two sites; At the site showing a weak response, less residue remained after seven years in the treatments giving the most pronounced effects.

Abstract | Full text in HTML | Full text in PDF | Author Info

Logging residues (LR), i.e. tops, branches, and needles, are increasingly being harvested for energy production in Fennoscandia. These residues are temporarily piled on site awaiting transport. This study was undertaken to investigate effects on the soil and soil-water chemistry below different amounts of LR at two recently harvested coniferous sites in Sweden. Seven treatments were included and the studied amounts of LR ranged from no LR left on the ground to four times the estimated LR amount of the harvested stands. Two treatments included eight times the estimated LR amount of the harvested stands but here the LR were removed after 7 or 20 weeks. Soil-water samples were collected during the first six or seven growing seasons. Effects of treatment were detected in the soil water for 11 chemical variables at the northern site, and for the NO₃^- and Cl^- concentrations at the southern site. The strongest response was generally found in the treatment with four times the estimated LR amount, for which the highest concentrations were recorded in most cases. In the first three seasons, the water flux through the LR decreased with an increasing amount of residue. Effects on the exchangeable store of Ca²⁺ in the mor layer and the upper 20 cm of the mineral soil was detected at both sites. At the northern site, the weight of the remaining LR, ground vegetation and all other material above the mor layer in the treatments with two and four times the estimated LR amount was roughly twice the corresponding weights at the southern site seven years after treatment. Although strong effects on the soil-solution chemistry were detected at one of the study sites, in the treatments corresponding to two and four times the estimated logging residue amount, the effect on the leaching from an entire regeneration area is likely to be relatively small given the percentage of the area hosting these logging residue amounts (ca. 20% after stem-only harvesting and 9% after fuel-adapted felling).

Ring, Skogforsk, Uppsala Science Park, SE-751 83 Uppsala, Sweden E-mail: eva.ring@skogforsk.se
Högbom, Skogforsk, Uppsala Science Park, SE-751 83 Uppsala, Sweden E-mail: lars.hogbom@skogforsk.se
Nohrstedt, Swedish University of Agricultural Sciences, Department of Soil and Environment, P.O. Box 7014, SE-750 07 Uppsala, Sweden E-mail: hans-orjan.nohrstedt@slu.se
Jacobson, Skogforsk, Uppsala Science Park, SE-751 83 Uppsala, Sweden E-mail: staffan.jacobson@skogforsk.se

article id 366, category Research article

Lars Eliasson. (2005). Effects of forwarder tyre pressure on rut formation and soil compaction. Silva Fennica vol. 39 no. 4 article id 366. https://doi.org/10.14214/sf.366

Keywords: soil density; cone penetrometer; final felling; till soil

Abstract | View details | Full text in PDF | Author Info

In Swedish forestry, final felling is usually done by a harvester and a forwarder. These machines are heavy and the risk for rutting and soil compaction can be considerable under unfavourable soil conditions. The aim of this study was to evaluate effects of forwarder tyre inflation pressure on rutting and soil compaction after final felling. Three levels of forwarder tyre pressure were studied, 300, 450 and 600 kPa, after 2 and 5 machine passages. The first passage was driven with a 19.7 Mg harvester, and the second to fifth passages with a fully loaded forwarder totalling 37.8 Mg. Rut depths were not significant affected by tyre pressures but increased significantly with the number of machine passages. Soil density was significantly increased by 0.075 Mg m–3 by the harvester passage. Soil density increased significantly with increasing number of forwarder passages, and tyre pressure did not significantly influence this increase but the interaction between number of forwarder passages and tyre pressure was almost significant. Data suggest that density increases occur earlier in the 600 kPa treatment than in the other treatments. Only parts of an area harvested are trafficked in a normal harvesting operation. Outside the research area approximately 12.5 per cent of the area harvested was covered with ruts. On primary strip roads, which are heavily trafficked, soil compaction cannot be avoided by reducing the tyre pressure. On secondary strip roads, not passed more than once by the forwarder, a low forwarder tyre pressure may reduce soil compaction.

Eliasson, Swedish University of Agricultural Sciences, Department of Silviculture, SE-901 83 Umeå, Sweden E-mail: lars.eliasson@norraskogsagarna.se

Click this link to register to Silva Fennica.

If you are a registered user, log in to save your selected articles for later access.

Contents alert

Your selected articles

Follow @SilvaFennica