Articles containing the keyword 'heartwood'

In laboratory studies the heartwood content seems to be the only natural property of a wood of different tree species influencing the decay resistance. Moistening and drying by diffusion happen quite slowly. Scots pine (Pinus sylvestris L.) sapwood takes moisture by capillary action quicker than pine heartwood and Norway spruce (Picea abies (L.) H. Karst.) wood. Swelling and shrinkage are also greatest in pine sapwood. Impregnation of pine sapwood can give it better hydrophobic and dimensional stability than that of pine heartwood.

The PDF includes an abstract in English.

• Kärenlampi, E-mail: pk@mm.unknown

The natural resistance of Finnish-grown Pinus sylvestris L. heartwood to Macrotermitinae termites was tested in Zambia in graveyard conditions. The heartwood exhibited some natural resistance but durability was, however, far from practical immunity. There was significant tree-to-tree variation in the resistance of heartwood of P. Sylvestris.

The PDF includes a summary in Finnish.

• Löyttyniemi, E-mail: kl@mm.unknown
• Uusvaara, E-mail: ou@mm.unknown

The study deals with the variation in the proportion of heartwood  in Norway spruce (Picea abies (L.) H. Karst.) and Scots pine (Pinus sylvestris L.) both within and between stems as examined on the basis of literature. Special attention is paid to an application, in which on the basis of the diameter of pulpwood bolts, efforts are made to predict the proportion of heartwood in the total volume of bolts. It is shown that the method, even when based on homogenous material of 564 Norway spruce and Scots pine bolts, easily leads to wrong conclusions concerning the proportion of heartwood.

The PDF includes a summary in English.

• Kärkkäinen, E-mail: mk@mm.unknown

A theoretical framework to analyse the growth of Scots pine (Pinus sylvestris L.) is presented. Material exchange processes and internal processes that transport, transform and consume materials are identified as the components of growth. Hierarchical system is lined out. Momentary uptake of material at a single exchange site depends on the environmental condition next to the exchange site, the internal state of the biochemical system of the plant and the structure of the plant. The internal state depends on the exchange flows over period of time and the structural growth depends on the internal state. The response of these processes to the fluxes is controlled by the genetic composition of the plant.

The theoretical framework is formulated into a mathematical model. A concept of balanced internal state was applied to describe the poorly known internal processes. Internal substrate concentrations were assumed to remain constant but tissue-specific. A linear relationship between the quantity of foliage and wood cross-sectional area was assumed to describe balanced formation of structure. The exchange processes were thus described as a function of external conditions. The stand level interactions were derived from shading and effects of root density on nutrient uptake.

The approach was tested at different levels of hierarchy. Field measurements indicated that the hypothesis of the linear relationship described well the regularities between foliage and sapwood of a tree within a stand when measured at functionally corresponding height. There was considerable variation in the observed regularities in the range of geographic occurrence of Scots pine. Model simulations gave a realistic description of stand development in Southern Finland. The same model was also able to describe growth differences in Lapland after considering the effect of growing season length in the parameter values. Simulations to South Russia indicate stronger deviation from the observed patterns.

The simulations suggest interesting features of stand development. They indicate strong variability in the distribution of carbohydrates between tree parts during stand development. Internal circulation of nutrients and the reuse of the same transport structure by various needle generations had a strong influence on the simulation results.

The PDF includes a summary in Finnish.

• Nikinmaa, E-mail: en@mm.unknown

The sustainability of native forests in Sub-Saharan Africa depends on the diversification of sources to generate bioenergy, and Eucalyptus spp. wood has been highlighted. However, the determination of energy quality parameters has been a challenge to enable plantation wood to generate energy. The research assessed the ash content of radial and longitudinal samples of Eucalyptus grandis (Hill) clone with different ages and growth sites. Samples were collected in three pre-established plots in the center of Mozambique. Five trees were cut down in each plot and six discs were removed from each tree. Grinded samples with <0.5 mm particle size were generated from the heartwood and sapwood of each disk to determine the ash content. Wood from 7-year-olds had a higher ash content compared to 9-year-olds. The two sample plots differed from each other in terms of wood ash content. Heartwood samples had smaller ash content than sapwood samples. In general, the ash content of the intermediate positions was lower than those from the base and top of the stem, for both radial sections. No conclusive differences were found between samples from the base and the top of the trees, indicating that the material from the top of the trees can also be used as wood fuel. Ash content can be a considerable parameter to assess the quality of the wood of Eucalyptus spp. as a fuel.

• Mogeia, Universidade Lúrio, Faculdade de Ciências Agrárias, Departamento de Silvicultura e Maneio [Lurio University, Faculty of Agricultural Sciences, Department of Forestry and Management], Campus de Wanaango, EN733, Km 42, Unango, Niassa, Mozambique E-mail: smogeia@unilurio.ac.mz
• Manhiça, Centro de Investigação Florestal, [Forestry Research Center], Marracuene, EN1, Maputo província, Mozambique E-mail: albertomanhica@gmail.com
• Egas, Universidade Eduardo Mondlane, Faculdade de Agronomia e Engenharia Florestal, Departamento de Florestas, [Eduardo Mondlane University, Faculty of Agronomy and Forestry Engineering, Department of Forests], Av. Julius Nyerere, Maputo cidade, Mozambique E-mail: aegas8@gmail.com

The paper aimed at testing the potential of refining tree rot diagnostics carried out by means of electrical impedance tomography (EIT). Examined was the use of EIT datasets with electrical resistance values and sapwood proportion determined on the basis of tomograms. Making use of datasets with resistance values in EIT rot diagnostics is not a default method, although datasets stay unaffected by a fixed colour scale and subsequent subjective evaluation unlike tomograms. Tomography measurement was carried out for 27 individuals of Norway spruce (Picea abies [L.] Karst.) in two stands north-east of Brno, Czech Republic. Once felled down, radial cut-outs were sampled at the measurement site and used for localising rot and determining the extent of the area of decay. The results were subsequently compared with tomograms. EIT datasets containing values of electrical resistance found by measuring were statistically processed and compared with the extent of rot area identified within the cuts. Sapwood proportion values were also detected using the tomograms. The baseline assumption that sapwood proportion decreases as the rot area in the radial cut expands was confirmed. In trees with rot percentage to 35% approximately, sapwood proportion was exceeding 30% except one tree. In trees with rot percentage exceeding 35%, sapwood proportion was below 30%. On the basis of interpreted datasets, the trees can be split into three characteristic groups that correspond to the occurrence, extent and nature of the rot.

• Humplík, Mendel University in Brno, Faculty of Forestry and Wood Technology, Zemědělská 1665/3, 613 00 Brno, Czech Republic E-mail: premysl.humplik@mendelu.cz
• Čermák, Mendel University in Brno, Faculty of Forestry and Wood Technology, Zemědělská 1665/3, 613 00 Brno, Czech Republic E-mail: petr.cermak@mendelu.cz
• Žid, Mendel University in Brno, Faculty of Forestry and Wood Technology, Zemědělská 1665/3, 613 00 Brno, Czech Republic E-mail: tomas.zid@mendelu.cz

• Víquez, Tropical Agricultural Research and Higher Education Center (CATIE), Apartado 7170 CATIE, Turrialba, Costa Rica E-mail: eviquez@catie.ac.cr
• Pérez, Ambiente Tierra S.A., Apartado 733-2250, Tres Ríos, Cartago, Costa Rica E-mail: dp@nn.cr

• Pérez, Ambiente Tierra S.A., Apartado 733-2250, Tres Ríos, Cartago, Costa Rica E-mail: diegoperez@costarricense.cr
• Kanninen, Center for International Forestry Research (CIFOR), Bogor, Indonesia E-mail: mk@nn.id

• Knoke, Institute of Silviculture and Forest Management, Technische Universität München, Am Hochanger 13, D-85354 Freising, Germany E-mail: knoke@wbfe.forst.tu-muenchen.de

• Björklund, Swedish University of Agricultural Sciences, Department of Forest Management and Products, S-750 07 Uppsala, Sweden E-mail: lars.bjorklund@sh.slu.se