Articles by Paavo J. Ollinmaa
Category : Article
The objective of the investigation was to determine the differences between timber grown on a peatland before and after draining, in respect of compressive strength parallel to the grain, static bending strength and density. In addition, the characteristics of boundary zone between the wood formed before, and after the draining with wider growth rings was studied. 41 Scots pine (Pinus sylvestris L.) and 22 Norway spruce (Picea abies (L.) H. Karst.) trees were studied.
The compressive strength of pine usually decreased from the butt end upwards, but no trend was observed in spruce wood. In coniferous trees, wide-ringed wood formed subsequent to draining was slightly lighter than the close-ringed wood produced prior the draining. The density of pine as well as spruce increases as the width of the growth rings decrease up to a certain limit. The strength of the different kinds of wood seems to decrease from the butt end upwards.
In both species, the compressive strength parallel to the grain and the bending strength are lowest in such wood that contains exclusively wide-ringed wood formed subsequent to draining. Also, compressive and bending strength increase with decreasing width of the growth rings. The longitudinal shrinkage of compression wood in spruce was several times that of normal wood, and the bending strength was lower than that of normal wood particularly in spruce. The compressive strength parallel to the grain in dry condition was, however, higher than in normal wood both in pine and spruce.
The PDF includes a summary in English.
-
Ollinmaa,
E-mail:
po@mm.unknown
Category : Article
The objective of the investigation was to determine the differences between faultless timber grown on a peatland before and after draining, in respect of compressive strength to the grain, volume weight, and shrinkage. In addition, the influence of the boundary zone between the close-ringed wood formed before draining and the wide-ringed wood produced after draining on strength of the timber was studied. The material consisted of 15 sample trees of Scots pine (Pinus sylvestris L.), Norway spruce (Picea abies (L.) Karst.), white birch (Betula pubescens Ehrh.) and silver birch (B. Pendula Roth).
The volume weight of wood of the tree species in ascending order is; spruce, pine, white birch, silver birch. The volume weight of Scots pine seems to decrease from the butt end upwards, while no trend was revealed for spruce. In the coniferous trees, the wide-ringed wood formed subsequent to draining was slightly lighter than the close-ringed wood produced prior draining. No distinct trend was seen in the birch species. The volume weight of pine and spruce increased with decreasing width of the growth rings up to a certain limit, after which the conditions inverted.
The compressive strength of the different kinds of wood seems to increase from the butt end upwards, but after height of two meters it begins to decrease considerably. In birch, this point of inversion is in somewhat greater height. In spruce timber, the compressive strength parallel to the grain is lowest for wood which contains exclusively wide-ringed wood formed after draining. The boundary zone between the woods formed before and after draining is very distinguishable, but has no remarkable influence on the compressive strength parallel to the grain. Shrinkage of close-ringed wood is higher in all three principal directions than that of wide-ringed wood. This can be explained by the variations in volume weight and fibrillar orientation of the tracheid walls.
The PDF includes a summary in English.
-
Ollinmaa,
E-mail:
po@mm.unknown
Compression wood of the tree species studied in this investigation, Scots pine (Pinus sylvestris L.), Norway spruce (Picea abies (L.) Karst.) and common juniper (Juniperus communis L.), was found to be characterized in its cross section by the thick walls and rounded shape of its tracheids and the profuse occurence of spaces. Tension wood of aspen (Populus tremula L.) and alder (Alnus incana (L.) Moench) was found in microscopic examination to be characterized by the gelatinous appearance of the wood fibres, by its small cell cavities and by the thickness and buckling of the inner layer of the cecondary wall. Tracheids of the compression wood were found to have shorter length than normal on an average, while the tension wood fibres were found to be longer.
The microchemical studies suggest a higher than normal lignin content in compression wood and lower than normal lignin content in tension wood, as compared to normal wood. The reverse would be true for the cellulose contents. Volume weight of absolute dry reaction wood was distinctly higher than that of normal wood. The longitudinal shrinkage of reaction wood, particularly of compression wood, is several times that of normal wood. Transversal shrinkage of compression wood is much less than normal wood. Swelling tests revealed pushing effect of compression wood on elongation and pulling effect on tension wood on constraction. Volume shrinkage of compression wood is less than that of normal wood, in contrast to tension wood. The strength of compression wood in absolutely dry condition was nearly same as that of normal wood.
The PDF includes a summary in English.
-
Ollinmaa,
E-mail:
po@mm.unknown
The investigation concerns with the strength of the eccentric growth accompanying formation of tension wood in silver birch (Betula pendula Roth.) and downy birch (Betula pubescens Ehrh.), behaviour of wood in wood-working machines and its macroscopic characteristics, its microscopic and sub-microscopic structure, chemical composition, resistance against certain chemicals, physical properties, and the strength characteristics of wood.
The most detrimental properties of tension wood used in wood working industry are high longitudinal shrinkage, warping, twisting and checking. The wooliness of the cut is unwanted, for instance, in plywood and furniture. In pulp industry tension wood is better raw material than normal wood because it yields more and purer cellulose than normal wood. However, it has poorer strength properties.
The PDF includes a summary in English.
-
Ollinmaa,
E-mail:
po@mm.unknown
